maxride, я катав за катером на прокатному борді, там плавники були лише по центру, з боків - ні.
Цитата:
Fins and placementThe closer the fins are placed towards the centre of the wakeboard, the quicker and better the wakeboard releases from the wake. The farther out towards the tip and tail they are placed, the longer the wakeboard will stay hooked into the wake and it won’t release as well.
Long based fins Their effect is almost the same as a short fin with a long base because they have a similar amount of surface area. Long-based fins release better, give the wakeboard a loose, snowboard-like feel when riding flat through the water, and they hold up better on rails and ramps.
Moulded fins These are just big channels in the board that act like fins and hold up on rails and ramps. Moulded fins are slippery, but most boards have a removable centre fin.
Multi-finned set-ups These capture the maximum edge hold and aggressiveness into the wake and through the wake.
Canted side fins These are fins that lean out on an angle. These fins are not as active when the wakeboard is riding flat through the water, but the more you lean on edge the more the wakeboard hooks up. The inside fin digs while the outside lifts, creating leverage to help the wakeboard edge hard. Great for 50-50 grinds, nose presses and tail presses.
Cupped side fins They have the same effect as canted fins but add more of a push-pull effect. The cupped fin allows you to use a smaller fin but still get the hold of a bigger fin due to the increased surface area of the cupped side of the fin. These fins are very deceiving – they look small and loose but really aren’t.
No Fins Some riders prefer to ride finless, as some boards are specifically designed for cable parks or other uses, some uses of which can benefit from a finless design.
|
Добавлено через 6 минут
Wakeboarder ::
Wakeboarder ::
Добавлено через 1 минуту
Тобто, як бачиш, середні докуповувати не варто, катай з боковими або можеш взагалі їх зняти=)
|